Clutch micro switch q

JC99

Well-known member
I have a clutch switch error on my dash. I know what the issue is. It’s a tiny rod that a clutch pull moves against a leaf spring to activate the micro switch. The leaf spring piece of metal then is supposed to push the tiny rod back into the clutch assembly once the lever pull is released. The problem is the rod is sticking in the “activated” position and the leaf spring doesn’t have the power to push it back. So I need to disassemble the clutch and clean the crud out of the rod sleeve and around the rod so it can move freely.

The question is what type of lube would be best to put on this rod afterwards to ensure it moves freely?

Excessive stiction from thick grease will give me the same issue I think and the wrong kind of lube will attract more crud and gum things up again. There is a rubber boot over this area that does help with protection a bit.

Also these are aftermarket levers but they are Pazzos and bike specific so I’m assuming the things should be working properly (they were fine last season with no errors).
 
I think dielectric grease should be good here as it isn’t too thick.

Is the lever adjustable? With my adjustable lever I made the throw too short and it didn’t travel long enough to move the micro switch. So I had to adjust it out a tiny bit to make it work. Just in case.
 
I think dielectric grease should be good here as it isn’t too thick.

Is the lever adjustable? With my adjustable lever I made the throw too short and it didn’t travel long enough to move the micro switch. So I had to adjust it out a tiny bit to make it work. Just in case.

That’s a good point.
 
I'd use a dry lube like Teflon spray long before I used anything that stays wet and collects dirt.
Agreed, dry lube for sure. I use WD40 Specialty Dry Lube and it works excellent. I bought it mainly for my bicycles but have found plenty of uses away from that.
 
Back
Top Bottom