Enough of COVID...what are you doing to the house?

Had some free time at lunch...

View attachment 80617
I programmed my self to dream about your space last night.... From an interior design perspective you should not be able to see the toilet from outside the room. Having said that, in a reno, I live in the real world and I always default to where the stack is, how the joists run, and not wanting bulkheads.... so my toilets can be seen. Just a data point to consider. If I had a perfect clean slate...

Instead of the open out door this is a perfect scenario for a 30" pocket door assuming the wall to the left of the door can be opened up and is not load-bearing, pocket door, NOT a barn door.
 
Outlet is actually missing. It's just the three wires capped with marettes and a copper ground. Was checking the wires in order to install an outlet and I find this.
Where is the outlet? If it is in a kitchen it was likely a split receptacle. If it is in a living room (or any room without an overhead light or otherwise fixed lights) it was likely a switched receptacle with one half always hot and one half switched. Even pretty old code required rooms without lights to have a switched receptacle.

As for the disconnected or otherwise broken neutral, that you will have to work back to find out where/what. HOPEFULLY someone in their infinite wisdom didn't put a switch on the neutral! It is a potential PITA but someone likely just left the neutral that feeds this outlet out of a pigtail upstream, hopefully it is not broken off, etc.
 
I have a similar system made by Stihl that fits on a leaf blower. Wear a raincoat as you will be coated with goo with the blower. Your vacuum solution is much cleaner.

If you want to get fancy, mount a camera with wifi on the elbow and tape your phone to the pipe so you can see where the leaves are.
I considered attaching my inspection camera to the top and mounting the screen at the bottom but with practice I have the technique down and there is not much need. I start at one end and I run it along the bottom on an angle as I work down the side of the house. I can feel if it is not on the bottom (mud) and repeat. Lift at every hanger. Then I do the same thing in the opposite direction.

I did set it up so it could be used in suction and blowing. I tried blowing on the prototype and it makes a mess of me and the ground. Leaves will sometimes get stuck at the end in suction mode, but they are not hard to get free.

One issue I have when it is wet and there is lots of old decayed crap (mud), the ribs in the shopvac hose get filled and the hose gets heavy. So I use the shorter hose (not my 25 foot one) as it is easier to clean.

I was going to get gutter covers, so far this is so easy that they are off the table....
 
Where is the outlet? If it is in a kitchen it was likely a split receptacle. If it is in a living room (or any room without an overhead light or otherwise fixed lights) it was likely a switched receptacle with one half always hot and one half switched. Even pretty old code required rooms without lights to have a switched receptacle.

As for the disconnected or otherwise broken neutral, that you will have to work back to find out where/what. HOPEFULLY someone in their infinite wisdom didn't put a switch on the neutral! It is a potential PITA but someone likely just left the neutral that feeds this outlet out of a pigtail upstream, hopefully it is not broken off, etc.
It's in a bedroom with switched outlets but the switch has one affect on it. There is a second outlet that my checker plug says has an open neutral. I'll be looking into that today.
 
It's in a bedroom with switched outlets but the switch has one affect on it. There is a second outlet that my checker plug says has an open neutral. I'll be looking into that today.
I suspect that you'll find that they used to be split plugs with half switched for lamps. Somebody tried to make them unswitched, screwed up the wiring and then gave up. Fix the wiring in the existing receptacle and it probably improves wiring in the empty box.
 
Bidet Toilet Seats... we are converts.

A good friend kept encouraging me to get one but I refused out of spite due to his extreme positivety (lol). Anyways, I bought one and my wife and I were immediate converts, so then the rest of the toilets got one the next week. I bought the basic Brondell ones from home depot/rona. Not heated, manual control. It uses the toilets cold water feed but in general it is not that cold in use and not an issue (like when you first turn on a tap). At this point I dread using TP... I hate to admit it my buddy was right....

I did actually plan ahead when I did my recent bathroom install and I put an outlet beside the toilet for a heated one, but so far I do not see a need.

Take the splash!
 
Bidet Toilet Seats... we are converts.

A good friend kept encouraging me to get one but I refused out of spite due to his extreme positivety (lol). Anyways, I bought one and my wife and I were immediate converts, so then the rest of the toilets got one the next week. I bought the basic Brondell ones from home depot/rona. Not heated, manual control. It uses the toilets cold water feed but in general it is not that cold in use and not an issue (like when you first turn on a tap). At this point I dread using TP... I hate to admit it my buddy was right....

I did actually plan ahead when I did my recent bathroom install and I put an outlet beside the toilet for a heated one, but so far I do not see a need.

Take the splash!
My first experience was in Korea with a fancy one. About a dozen buttons, all writing in Korean, pre-google translate. The learning curve was damp. At some point I'll get at least one. Putting them on all the toilets would probably cause more issues than it solves.
 
My first experience was in Korea with a fancy one. About a dozen buttons, all writing in Korean, pre-google translate. The learning curve was damp. At some point I'll get at least one. Putting them on all the toilets would probably cause more issues than it solves.
These ones are simple... turn the knob backwards and it does your back part... turn it forwards and it does the front for the ladies. The knob is variable for pressure. Sprayers pop out from the pressure and retract when off. Other than that it functions like any-other seat. It comes with a fitting that goes on the toilet valve to split off the water.

Pro-tip, don't turn the knob while not sitting (to see what happens)... it sprays across the room.
 
Bidet Toilet Seats... we are converts.

A good friend kept encouraging me to get one but I refused out of spite due to his extreme positivety (lol). Anyways, I bought one and my wife and I were immediate converts, so then the rest of the toilets got one the next week. I bought the basic Brondell ones from home depot/rona. Not heated, manual control. It uses the toilets cold water feed but in general it is not that cold in use and not an issue (like when you first turn on a tap). At this point I dread using TP... I hate to admit it my buddy was right....

I did actually plan ahead when I did my recent bathroom install and I put an outlet beside the toilet for a heated one, but so far I do not see a need.

Take the splash!

We can’t do without them now. Even bought travel ones for vacation. We’ve become bog snobs.
 
Back
Top Bottom