Would it be possible to to use some stiff card and make paper templates that fit the internal contours?
I would think based on what you're doing you don't need much more than accuracy to decimal points. 10 thou vs 1 or 2.
With scissor s and paper you should be able to get within 10 thou.
Spooned a new rear on yesterday. This morning I'll go out and see if the pressure has dropped over night. A new front is in the post. Both from FortNine.
Both the tires I'm replacing have maybe half their life left but I'm leaving on a trip soon and hate to head out on the last half of a tire...
While reading the book above I found it very offensive to learn that Netanyahu assisted Qatar in funneling many millions into hamas. As long as Gaza was run by terrorists he would never have to negotiate with them.
Netanyahu is a war criminal and isreal is an aparthied state. What an effing...
When I was looking for the bearing cap I ended up digging out a large section of old cast iron water pipe. Ended up with a pretty big divot in the lawn.
That's actually a bad example. Small wheels are harder. I remember fighting with tires on my trailer (8" rims) after some how getting one on I simply could not get the second and ended up buying a whole new rim/tire.
Well fack me! I'm a rock of indecision. Luckily the Squeeze always provides good counsel.
She didn't think much of buying a new trailer and hacking off the ramp. "do more research??.."
Now I'm thinking about this. Just a 5x8 trailer kit. Even lighter at 250lb. Skinning the deck with 1x6 deck...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.