dragonrider
Well-known member
Hi guys, I bought a used r6 recently and just noticed today that it seems the lock for my master link in my chain is missing. See the pic. Could someone tell me if it is normal? If not, why should I do? Thanks a lot.
|
|
|
is my master link normal?
- Thread starter dragonrider
- Start date
dragonrider
Well-known member
Isn't there a lock to lock the master link in place so it won't slip out?
RC-31
Well-known member
That's a rivet link. It looks fine.
What you're thinking of is a clip type master link. Those ones have the locking clip.
Notice how the ends of the pins on your master link are dimpled in the middle? That's one way you can tell.
Clip type master links will not have a dimple; they will have a groove to hold the spring clip.
What you're thinking of is a clip type master link. Those ones have the locking clip.
Notice how the ends of the pins on your master link are dimpled in the middle? That's one way you can tell.
Clip type master links will not have a dimple; they will have a groove to hold the spring clip.
dragonrider
Well-known member
Oh. Thanks. Ok, no worry then. I can ride once the rain stops. 
ItIsWhatItIs
Banned
Oh. Thanks. Ok, no worry then. I can ride once the rain stops.
Get your hands on the sm and a vernier and measure the spread of the rivet to be sure it's on right.
dragonrider
Well-known member
thanks. I am getting a chain tool. Once getting it, I will probably change the chain as it looks worn to me.
Make sure you buy a quality chain, DID, EK, RK, etc. None of this no-name brand ebay junk
-Jamie M.
-Jamie M.
The info would be included with a new chain.
for DID....skip to the third page....http://www.didchain.com/chainTools.html
Doesn't give the measurement tho. I will stick to the measurement of the factory revit
My bad, I was reading all the wrong places
-Jamie M.
Well.....arnt you fancy?
The tips of those rivets don't look flared enough. I just replaced my chain and I flattened the rivets more than that.
|
|
|
|
|