2014 ZX6R fender eliminator

[xX-GMan-Xx]

Forum Sponsor

Can anyone help me look for a license plate mount for the 2014 ZX6R that can be placed a little farther under the tail section. the one I presently have is placed under the far tail end where original fender eliminator was attached. please see the pix.

I would prefer to avoid drilling any holes.

 

[SWH]

Don't know if you need to drill holes or not. http://www.ebay.ca/itm/2013-2015-Ni...ash=item2c9c121159:g:n2YAAOxyDEVScA6j&vxp=mtr

I would think most are closer to the rear of the tail due to them bending when the suspension bottoms out if you hit a bump in the road.

 

[Benny!]

Try a zx6r forum. Be a ton more suggestions

Sent from my Nexus 5 using Tapatalk

 

[matthew]

If you move it too far back, your'e risking a ticket.

 

[xX-GMan-Xx]

Don't know if you need to drill holes or not. http://www.ebay.ca/itm/2013-2015-Ni...ash=item2c9c121159:g:n2YAAOxyDEVScA6j&vxp=mtr

I would think most are closer to the rear of the tail due to them bending when the suspension bottoms out if you hit a bump in the road.

This looks pretty neat. a bit on the expensive side though. Thanks for the share!!!

 

[xX-GMan-Xx]

If you move it too far back, your'e risking a ticket.

I met a guy who had pasted the lic. plate to the inclined surface under the tail...

He said he never had a problem with Cops. but then again he was like "Oh before he stops me I'll be long gone" whereas; I don't wanna risk that.

 

[esphoto]

I helped a buddy relocate his further down on an '07 CBR600RR; looked nice but got bent, and within a week got a text asking to help relocate since he got a ticket.

My 2cents...I think it looks fine where it is.

Just took a look and the Competition Werkes one that SWH posted up was the only one I could find also.

 

[-Maverick-]

Seems like popo everywhere are using aftermarket undertail plate holders as a reason to pull riders over. Your best bet is to keep the stock location.

Forum Sponsor