Recent content by meester_jamie

I know Paul very well ,,I should have known this! Thinking, Wayne at Cambridge Custom Cycle should be able too! Thank you

I need to get a 2002 Honda appraisal to transfer ownership,, any recommendations ? Bike is located in Cambridge

I took the last ride a little further than I should’ve,, but once I got over that ,, we got about 4hrs more ,, you can see the first pass I didn’t go as deep ! Lol March 14 2022

9 yr old Granddaughter loves to ride ,,

Thanks joe !

https://m.ebay.com/itm/E-marked-12V-Motorcycle-7-High-Low-Headlight-Front-Lamp-With-LED-Running-Light/201924744360?_trkparms=aid%3D111001%26algo%3DREC.SEED%26ao%3D1%26asc%3D20160908105057%26meid%3D0e7cb13a732d415599d0130ef411fb8c%26pid%3D100675%26rk%3D1%26rkt%3D14%26sd%3D201924744360%26itm%3D2019...

I don’t think you can install that flasher relay on your bike ,, but you can connect a buzzer like robmack said using one like this...

Are cars different from bikes? My daughter wasn’t listed on the car policy, hit another vehicle... insurance says I’m ok with 1st accident so they cover all costs, and the issue with her driving without being listed was covered as 2nd forgiven accident allowed by my policy

As for snowmobiles on wheels , i Wave arm outstretched, wrist bent, limp hand down,, funniest looks lol

I had a Harley rider approach ,, seem to put arm in waving position , but hold it back till I was nearly on top of him , then this HUGE wave and he did a u turn ! Caught up to me at a light and explained ,, he thought my BSA low rider chopper might be a Suzuki savage! No way he was waving to jap,,

I had a rented lowered road king , parked on a slight hill,side stand on the uphill side and it blew over the stand side, winds were no where near yesterday,, I rode home from PD13 where winds were very strong and all bikes in group were leaning about 30 Deg into wind,, and a couple of us felt...

Is this information relevant? http://www.endofsuburbia.com ,,

.035 wire is larger than I would use,, and I have seen the issue with welds that don't have penetration to come from poor supply to the machine..... tooo long of a feeder to the recept,, too long of an extension cord... wire awg too small... 12awg, very short run to the main feeder,, or 10awg ...

you don't have to wait for the load to go up.. the infrastructure required to install a charge has to be taken into consideration in the LDC Rates as of right NOW...(rate applications for increase to your bill are submitted already) because every building permit * as of 2018 will require a 200A...