Looking over my new to me 2015 VFR and noticed that the coolant reservoir was low; as in barely above the outlet. I decided to take off the bodywork!! to get at the rad cap to see if the rad was full. The level is about 1" below the pressure washer level. I presume it should be flush.
The bike has 3,000 km following service at a local Honda shop , so I'm assuming it's leaking and therefore looking for a leak. I found a location on the left side immediately above the pump at a three-way junction that to me looks like a potential leak. I'm looking for some help with this. Does the white deposit indicate a leak? Is it any good to tighten the clamp or given the time and effort with the bodywork take it apart and clean it? Maybe this is like discussing engine oil change interval.

The bike has 3,000 km following service at a local Honda shop , so I'm assuming it's leaking and therefore looking for a leak. I found a location on the left side immediately above the pump at a three-way junction that to me looks like a potential leak. I'm looking for some help with this. Does the white deposit indicate a leak? Is it any good to tighten the clamp or given the time and effort with the bodywork take it apart and clean it? Maybe this is like discussing engine oil change interval.
