There is no turbo zx-14r, the guy is clearly a speed junkie and modified his zx-14r lol =P
LSL handlebar conversion kits by spieglers
- Thread starter 油井緋色
- Start date
There is no turbo zx-14r, the guy is clearly a speed junkie and modified his zx-14r lol =P
MTRCYCLS
Well-known member
Only the turbo version, and it has to be a '06,' 08 or '10. The '12+ 14r wont work because the key hole doesnt line up.
I think this is the route I'll have to go but it will have to wait a few years =(
$$$ doesn't grow on trees sadly.
Johnny is right about COnvertibars. They are basically unlimited for adjustments. Bar angle via an eccentric where bar tube enters the bar clamp.
Height via an L shaped bar clamp that can be slid up and down. Fore and aft as well as width can be adjusted via the "Cyclops clapm", which is basically a figure 8 shaped clip on fork clamp, that can be spun any direction around the fork, allowing the bar clamp, and ultimately the width and fore/aft placement of the entire setup to be tailored to just about anywhere the rider wants, Provided it doesn't hit the fairing and tank. Many riders will also trim the fairing to allow more room for these. While expensive, the COnvertibars are the class of the class for adjustable clipons so far.
Height via an L shaped bar clamp that can be slid up and down. Fore and aft as well as width can be adjusted via the "Cyclops clapm", which is basically a figure 8 shaped clip on fork clamp, that can be spun any direction around the fork, allowing the bar clamp, and ultimately the width and fore/aft placement of the entire setup to be tailored to just about anywhere the rider wants, Provided it doesn't hit the fairing and tank. Many riders will also trim the fairing to allow more room for these. While expensive, the COnvertibars are the class of the class for adjustable clipons so far.
EaZ8
Well-known member
check out Helibars. they dont have KTM listed, but i like the design of them better. it clamps on the tube and raises the bars above the trip-trees
if you contact them they may have ones that will fit the fork tubes.
https://www.helibars.com/
if you contact them they may have ones that will fit the fork tubes.
https://www.helibars.com/
