Hey all, after adjusting my screen to the high position, I've also added an extender on the base which gave it an additional 2", plus the screen extender which is another 2-3". With covid around I haven't had much highway trips, so it just occurred to me now that it seems a bit buzzy and I feel like that thing would tear off eventually. I've checked all screws and nuts and have all rubber washers. Tried wiggling it at idle and everything seems solid. Should I be concerned? Should I swap to the puig givi etc screens since it'll be a one piece? Thanks for reading.
|
|
|
Cb500x windscreen
- Thread starter Chrispy
- Start date
ScorpionT16
Well-known member
Can you post a picture, hard to imagine what you've done. I had a 2016 CB500X, windshield on highest setting, with a wind deflector on top. No issues with stability, however the stock rubber grommets with the nut holding the shield on did get brittle overtime, so I got some new grommets, bolts, and nuts from Lowes and it was much more solid vs the pressure fit the stock setup uses.
Hey @ScorpionT16 , basically what you have. High setting with reflector plus this additional adjuster, hard to see from taking a pic. 
|
|
|
|
|