Search results

If you can get a hacksaw blade into the gap where the pinching occurs, get in there and cut the bolt in half. Then extract each half.

I have one just like it in my dining room. It was my grandmother's, and it's in much better condition; useable I'm sure.

OUCH! :eek:

I wanted a flag/light mount for my Zodiac but I didn't want to drill holes into my transom, so I made this out of a combination of flattened ABS pipe, and a piece of pipe with a threaded insert at the top. It slides on from the top and is held in place with the factory installed launching wheel...

Just the standard ABS plumbing pipe cement. Its cheap. You don't have much time to apply it before it sets up. I've made loads of things out of ABS. With the flat stock you can add pieces like gussets and stiffeners by gluing pieces together.

In the past I have sometimes made ABS paste by combining ABS chips and filings with glue; mix it all up. You can also melt slivers of it onto a cracked or broken piece using a soldering gun, effectively welding it. I've also cut ABS pipe along its length and heated it up in the oven until its...

I sent the form in 5 days ago and still haven't received a reply.

Town of Georgina is in the process of installing a bunch of these. The posts are up, and the signs in place but the cameras aren't mounted yet.

You could try making a mock up out of wood to test for fit.

Coincidentally, I demonstrated the use of a bore gauge during his visit.

I've been using these guys in recent years, mainly because they are close to me. They have high end modern equipment and do a nice job for about 50 bucks. https://www.edgeperformance.ca/en/

I've had the same battle with 8" trailer tires. A couple of days ago I put 2 new front tires on my lawn tractor. I used this method. It was pretty easy. I used C clamps to break the beads.

And add some out of round wheels!

Nice to meet you Mr. Nuggy! Glad to help. Pass it on... :^)

If its ABS use a scrap of plumbing pipe, (heat it and flatten it) and some ABS cement.

Not the ones I got.

I've found a few very large impact sockets at Princess Auto, in the Surplus Section. They're labeled for suspension components on cars. There's an odd assortment, always changing. Sometimes they have the one you want. They look pretty decent and they're cheap. Likely not Snap On quality, but...

Doesn't it have a drain plug?

I'm in need of a new NG fired BBQ and have been looking for quite a while. For me, a side burner is essential. I use mine a lot. They seem to be getting harder to find.