I need to fabricate an engine stand for a 4 cylinder motorcycle engine. Obviously it must be robust. My first attempt was based on 1" square steel tubing but it proved to be inadequate. I need some 3/16 or 1/4 steel plate for the next one. I looked high and low but can't find any at a reasonable price in Toronto. Lots in the US but postage is a killer. The steel is basic, nothing fancy, cold rolled is fine.
I only need a few small pieces. Any suggestions for sourcing it in the GTA?
This crankcase splits vertically like the old British twins not horizontally like the Japanese fours.
Paul
I only need a few small pieces. Any suggestions for sourcing it in the GTA?
This crankcase splits vertically like the old British twins not horizontally like the Japanese fours.
Paul