Can't remove carburetor assembly

[Brampton-F2]

Hey guys, I'm in the process of removing my carburetor assembly. I loosened the four screws om each of the rubber sleeves. I tried to move it back and fourth while pulling but it won't budge. I've read wd-40 and hair dryer to make it easier to get off. Any advice on this? The bike is 93' Cbr 600. It's probably cause its really old but interested to learn any tenniques.

 

[GateKeeper]

if it's all loose, then it's just a matter of moving and jiggling until it lets go, really make sure all is loose, you can try and spray a bit of silicone grease between the boots and carbs and see if it frees them up....if the boots afterwards you find they are hard, it's time to replace....

.