Search results

yup..called ready powersport they say they dont have speed r s ..thinking of just getting rf-1100

great info will give all of them buzz. thanks again

I went to snow city yesterday. All excited, I asked if they have any speed R. The lady pointed at the showcase where they had 4 shark helmets (literaly) and that's all. I asked if they can order me one; she was not clear on her answer if they can or not. In other words, no

Thanks. I am medium with rf-1100 but according to chart i am small... so lets see

Thanks for quick reply. I did check out websites out of states; I have no problem shipping it there as I have a local address there. I am just concern about the fitment and accuracy of the size chart. I fall into size S according to the guide (55-56 cm). My Q is has anyone order helmet by just...

I have been looking for a month calling most of the known dealers for this helmet and no one seem to have stock or cant even order it for me. Ideally I would like to try this one before I buy it and shark sizing chart is still very general. please reply if you know of any store of dealer that...

ok so I could not get to all of it but did check plugs gap cleaned air filter (still waiting to dry and re oil and install today) meanwhile, I noticed this T-piece came out of carbs (attached drawings) .. I wonder if this could cause the lag

I started noticing this after i changed plugs. so I will be opening her up to see whats going on. going to follow the check list - check plugs and gap - check vacuum lines - clean air filter and re oil (k&n) - run seafoam - fuel pump ( it seems to be after market .. prob previous owner put it...

Also, it is old and carbed so that could be it. dont wanna spend too much time and money taking it apart.

I dont recall what gear but I think Seafoam is good idea.

Hello Everyone, Bike in Q is 1998 ZX-6R. Problem : When I am going at constant speed (e.g 100kph) for a bit, and I try to give it by turning the throttle fast.. it experiences sort of a power loss for 2-3 seconds before it picks it up and goes. I have experienced this few times now so I...

Saw what seemed like a cruiser down with 2 ambulances around. Complete standstill. Hope the rider is ok

thanks for getting back. I have replaced oem banjo with what galfer lines came with. i adjusted the lever and checked for air. bleed the lines about 3 times to make sure there is no air. lever comes half way when brake it fully applied

looking for 98-02 ZX6R front fender asap. preferably green. I am located in Toronto downtown are but I am willing to pick it up from anywhere or get it shipped. thanks

lol. i know I sound all over the place. Ok. My question : Is it normal for this bike or any other bike that is this old to have brake lever travel almost half way when brake is engaged completely? even after installing braided brake lines. I have experienced new bike brakes engage within an inch...

Hello all I took out original lines and installed Galfer Braided lines on my 98 zx6r. I hated the spongy feeling before. rear brake is much better and hard, pedal does not travel much before it bites. front brakes are better but not as good as i thought it would be. the lever is almost half way...

Uploaded with ImageShack.us

interesting . i did take off the tank earlier this month to do some work . I was confused on how to route the vent tube. will check that out as well

i ll try seafoam . went for a 7 hour ride on sunday. no problem atall. bike is f***ing with me

now when i think about it i think it happen every time I press the throttle to go lil faster. vaccum leaks somewhere?/?