Recent content by Cheesemuffin

Yah its the mastercraft wrench..I bought it right before i started taking apart the front end and within an hour this happened. I had the receipt and everything and it was on the same day within a few hours...like the whole management was there. IT was stupid

Rant start: ...After realigning my forks, the torque wrench i bought (Mastercraft) from crappytire malfuctioned and didnt CLICK when i was tightening the giant bolt that holds the triple tree together. I realized it wasnt working as it should because it clicks a couple of times if you are over...

you wouldn't happen to be taking BJJ at Lin Martial Arts would you?

dam... Im prob going to buy the aerosal can and spray the coats. I've done model painting before when i was a bit younger so it shouldn't be an issue. Im not a complete dope at painting. i just dropped by kahuna and they ordered me the L/H front signal. Dam pricey.....

hahhaha.. 33$?!?!? THats it!? im going down there now then! PS im replacing my current frame sliders to the shoguns.. the frame sliders right now are a POS. Im going to purchase the nocut shoguns. They're mounted on BOTH engine bolt mounts. The one i have are only connected to the upper bolt...

So i went down riding last night taking a hard left turn and slipped on gravel. I was lucky to only have a small abrasian on my left knee. Jeans are completely gone (I have my leathers on order and wont be getting in till next week..just my luck..) Only my left turn signal was broken and my...

I saw a bunch of bikes at pizza pizza at midnight. Iono if it were you guys. Whoever was there all looked at me when i rode by:P I was on a blue ninja 250

gonna join in for a bit!

Yah, the new design has the fins as sheet metal with ridges already. The fins are detachable with a bolt once the panels are unlocked. As for the housing for the lock I did realize that people could just bolt-cut off the lock or hammer the housing off. I made the housing large enough so no...

to keep cost down im using 1/8" sheet metal and reinforce it with steel bars. This will reduce the cost substantially and provide it will strength. Originally I had it at 1/2'' steel sheet metal but it would cost too much more to bend and cut it. Also, this adds a ton of weight to the bike...

Sorry heres a picture: Mind you this is the idea not the final. The positioning of the lock has been placed on the outer side of the front wheel due to clearancee issues

I've noticed a lot of bikes are being stolen in pathetically guarded condo underground parking lots. So i've decided to design an anchor that doesn't have to be bolted to the ground but makes it extremely difficult for thieves to break through and/or lift the whole bike with the lock into a van...

I just started work and am living in markham for the next 4 months. Mind you im from mississauga/oakville area where the drivers are ALOT better. I have never been so enraged riding.. I actually try and speed up to the front of all traffic so i dont get stuck when some **** happens. Funny thing...

nvm i remember you passing on the broken and the red ninja barely made before the turn and I made a split second decision to gun it and follow. oh boy. So when are we riding again? I've got myself a new pair of undies. :)

The one i tried following you in that corner when you passed on the double solid? Got my heart going so fast.. (Never doing that again) Think I could get a clip of that?