nitescream
Active member
I am selling my 2007 Honda CBR600RR
Includes:
- Power Commander 3
- Full Yoshimura exhaust systems
- Frame sliders
- Intergrated taillight
- Flush front signals
- Signal flasher box (different flash patterns)
- Shorty levers
- Alarm system
Oil changed full synthetic. Month ago
Work done on June 6th by PRO6
- BRAND NEW Dunlop Q3 rear tire installed
- BRAND NEW rear brake pads installed
Runs Awesome
$5950. Need gone asap. Will continue to ride until sold.
Little information on the 2007
2007-2008 redesign
The CBR600's most radical redesign since the introduction of the RR in 2003 is highlighted by a whole new engine, frame, and bodywork that results in a smaller, lighter, more-powerful CBR600RR with a class-leading power-to-weight ratio and unparalleled performance.
Weight was the primary focus of the redesign. The result was a 9.1 kg (20 lb) reduction in dry weight over the 2006 model, from a claimed 361 lb (163.7 kg) to 341 lb (154.7 kg). Tested weights without fuel were 182–182 kg (401–402 lb).
In redesigning the CBR600RR for lighter weight and increased performance, Honda's engineers started with the engine. The completely new engine was smaller and lighter than its predecessor, the designers having used careful positioning of all internal components to achieve significant reductions in the motor's length, width, and height, as well as reducing weight by 2 kg (4.4 lb) compared to the 2006 model's powerplant. Horsepower increased to about 105 hp (78 kW) measured in independent tests.
The frame was lighter, slimmer, and more compact than that of the 2006 CBR600RR. The frame was produced using what Honda calls Fine Die-Cast (FDC) technology, which allowed them to build a lighter frame without compromising strength or rigidity. The handling of the new bike was sharpened by its 22 mm (0.87 in) shorter wheelbase, as well as by the designer's focus on strict mass centralization. Despite the shorter wheelbase, the 2007 model's swingarm was 5 mm (0.20 in) longer than that of the 2006, made possible by the more compact dimensions of the new bike's engine.
The suspension of the 2007 model was carried over almost unchanged from the 2006 bike, with the same 41 mm (1.6 in) inverted fork in front, and Honda's Unit Pro-Link rear suspension configuration damping the rear wheel. The new three-spoke cast aluminum wheels were also lighter than those on the 2006 bike, which further contributed to the enhanced performance of the suspension. The brakes featured dual radial-mount four-piston calipers and twin 310 mm (12 in) discs at the front, and a single-piston caliper and a 220 mm (8.7 in) disc at the rear. Hidden below the steering head was an updated version of the Honda Electronic Steering Damper (HESD) system, which was also available on the CBR1000RR.
The smaller, sharper-edged new front upper fairing was dominated by the large central ram-air duct which fed the airbox through an opening in the steering head section of the frame and was separated from the sides of the fairing by a large gap which Honda said was for air management purposes. The tail-section was similarly smaller and sharper-edged, riding atop a heavily restyled under-seat muffler.
Last edited: