The short answer is yes! It most certainly is.
The longer answer is that the bar has a plug in the end that is welded in place, and then there is a cap that has a bigger diameter then the tube welded to the end.
i found this out the hard way. I thought I could drill and tap the plug, then use a slide hammer to pull the plug out, that would allow the tube to come out from the mount.well that’s not the case,ended up breaking off the mounting tab. I should have just put it in the mill from the start.
a fine member from this forum (aloyas thank you very much) bailed me out as there was no budget for handlebars.
anyway I found this out when I cut it in half, I have tried to post the pictures but it’s not working for me I can’t get the pictures small enough. I thought I made a donation to make this easier,anyway if I could email them to someone maybe they could make them appear. P.S. I don’t have a computer
The longer answer is that the bar has a plug in the end that is welded in place, and then there is a cap that has a bigger diameter then the tube welded to the end.
i found this out the hard way. I thought I could drill and tap the plug, then use a slide hammer to pull the plug out, that would allow the tube to come out from the mount.well that’s not the case,ended up breaking off the mounting tab. I should have just put it in the mill from the start.
a fine member from this forum (aloyas thank you very much) bailed me out as there was no budget for handlebars.
anyway I found this out when I cut it in half, I have tried to post the pictures but it’s not working for me I can’t get the pictures small enough. I thought I made a donation to make this easier,anyway if I could email them to someone maybe they could make them appear. P.S. I don’t have a computer