Zumo 550 touch digitizer | GTAMotorcycle.com

Zumo 550 touch digitizer

Baggsy

Well-known member
Site Supporter
The touch display went while I was in Vermont.

The Zumo kept thinking that parts of the screen were pressed and held down, that weren't, so it wouldn't even move to the map page.

I purchased a couple of digitizers from China on ebay ($7.64 U.S. each), and they arrived today.
ebay digitizers



I just finished installing one using a couple of threads on other sites (it appears to have been a fairly common problem after a few years of use).

The one issue, was that my Zumo uses T6 torx screws, not T7, and my fingers are large for trying to install the ribbon wires back into their slots.

So far it appears to work, but I'll do a full test ride tomorrow.

http://advrider.com/index.php?threads/zumo-touch-screen-and-digitizer-replacement.528905/

http://www.fjrforum.com/forum/index.php?showtopic=141426
 
I had the digitizer go on my Zumo 550 many years ago.
I followed similar links to replace it as well and ordered from overseas.
Took me a long time to get it done the first time. I then helped a buddy do his digitizer after.
Re-installing the ribbon wire was the most difficult part of the replacement.
Well done sir!
 
Sorry, that was two issues.

The test run run was a success. It appears to be back to it’s original condition, and its amazing how much deterioration I put up with over the years.
 
I have a zumo 550 in the box, with everything. Needs a digitizer.
If anyone wants it, pm me an offer.
 

Back
Top Bottom