Installed 2 led front signals and a rear integrated tailight, tailight has 1 wire for each turn signals and uses the stock connector for the brake light which is grounded. Front signals have 2 wires each, power and ground. Signals are installed correctly, flash correct ways left & right. Replaced the relay and still had hyper flash. Got a replacement from the seller which I installed. Hyper flash continues and now bike won't start so I reverted back to the original relay from seller.
Tried disconnecting rear turn signals still hyper flashes, tried the same with the front. Crimped the two grounds in the rear from the stock connectors not being used, still flashes, tried to ground them separately, still flashes.
Not sure what the problem is or if I just have a ****** batch of relays from the seller. Any suggestions as to what's wrong would be appreciated
bike is a 2015 gsxs 750
Tried disconnecting rear turn signals still hyper flashes, tried the same with the front. Crimped the two grounds in the rear from the stock connectors not being used, still flashes, tried to ground them separately, still flashes.
Not sure what the problem is or if I just have a ****** batch of relays from the seller. Any suggestions as to what's wrong would be appreciated
bike is a 2015 gsxs 750