I'm rebuilding a Yamaha DT400C engine and I want to get some work done before I put it back together.. I have the cases split now and everything is out
I want to make sure all of the mating surfaces are good and level, I don't want to find out they are warped later on
I need the cylinder bored to the next oversize, and I want the crank rebuilt for piece of mind
I contacted Bondi Engines to see if they can do it. Does anyone else have the ability to do this work??
I want to make sure all of the mating surfaces are good and level, I don't want to find out they are warped later on
I need the cylinder bored to the next oversize, and I want the crank rebuilt for piece of mind
I contacted Bondi Engines to see if they can do it. Does anyone else have the ability to do this work??