Not to sure what parts i need.

R

redslash

New member

• Oct 2, 2016

• #1

Not fully 100% sure what parts i need. Had a little highside accident and bent my right handle bar and the little metal frame that holds my rear brake.
Thinking i just need the right handle bar piece (starter works, throttle rolls but wont spring back) and bar end? And the metal frame part?
heres pics
https://gyazo.com/3895ca9ede707daaa989781853d20fcb
https://gyazo.com/e382a06647956f8a060d577063e333b4

any advice would help.

 

Riceburner

Well-known member

• Oct 2, 2016

• #2

Kawi?

Use this as a startling point for part #s:
http://www.flatoutmotorcycles.com/OEMpartfinder.htm

Looks like you might just get away with the right handlebar and foot peg mount.

 

R

redslash

New member

• Oct 2, 2016

• #3

cbr300r

 

Riceburner

Well-known member

• Oct 2, 2016

• #4

try:
http://www.bikebandit.com/oem-parts/honda-motorcycle-parts/s/m6


http://www.bikebandit.com/oem-parts/2015-honda-cbr300r/o/m156899#sch908149

http://www.bikebandit.com/oem-parts/2015-honda-cbr300r/o/m156899#sch908180

 

viccont

Well-known member

Site Supporter

• Oct 4, 2016

• #5

Could be all fixed without buying new parts

 

TwistedKestrel

King of GTAM

Site Supporter

• Oct 4, 2016

• #6

It's unlikely the bar-end itself needs to be replaced (unless it's scratched up and you would like to replace it for cosmetic reasons, which is fine) just the bolt holding it to the handlebar

 

boyoboy

Well-known member

• Oct 7, 2016

• #7

if the throttle drags you may want to replace the handlebar. look closely. test for drag. when and if you do change the handle bar, just loosen all the parts on the handle bar enough to slide out the old handlebar - and then slide in the new handlebar, don't take everything apart.

 

Last edited: Oct 7, 2016