Cornering. What RPM and gear should you be in before entering on a 600ss

RedDogDarren · May 20, 2016

dricked said:
6th at 12,000rpm

As said above, way too many variables.

Incorrect.

ALWAYS redline in 1st gear.

inreb · May 20, 2016

GixxerL2 said:
Jeez, it's like asking what position is best to make love with your woman. It's better for you to watch how Marquez does it on the track

That was not a woman, that was Jorge Lorenzo. Easy mistake to make, people call him JLo.

N3WMAN · May 20, 2016

dricked said:
6th at 12,000rpm

Beat me to it. Pretty much the gold standard. Works in any type of corner. I didn't believe it until I tried it.

GreyGhost · May 20, 2016

stupid comment removed

taximan62 · May 20, 2016

I think you all got trolled

mikbusa · May 20, 2016

5252 rpm. This way your hp matches the torque. Balanced approach.

Dino Z · May 21, 2016

It always depends, however I find being smooth in corners requires not being too low in a gear.

Try being in a higher gear than you think, if too tall back off one.

Dr. Luxurious · May 21, 2016

OP...do everyone a favor, keep it at zero rpm...any gear is fine.

cycling · May 21, 2016

What can I say? Absolutely love some of the answers. Can`t stop laughing. Thanks.

Jayv · May 21, 2016

Powerband....

Sunny87 · May 21, 2016

N3WMAN said:
Beat me to it. Pretty much the gold standard. Works in any type of corner. I didn't believe it until I tried it.

Thanks for the pro tip. Gonna try it out today.

I'll keep you posted on results.

ZX600 · May 21, 2016

Check your rebound

Cornering. What RPM and gear should you be in before entering on a 600ss

RedDogDarren

Well-known member

inreb

Well-known member

N3WMAN

Well-known member

GreyGhost

Well-known member

taximan62

Well-known member

mikbusa

Well-known member

Dino Z

Well-known member

Dr. Luxurious

Guest

cycling

Well-known member

Jayv

Well-known member

Sunny87

Well-known member

ZX600

Well-known member