CBR250R Oil Change w/ Part Numbers & Torque Settings Video | GTAMotorcycle.com

CBR250R Oil Change w/ Part Numbers & Torque Settings Video

BrownBrady

BrownBrady

Well-known member
Just sharing this video on how perform an oil change on a Honda CBR 250R. Credit goes to all the advice from the experts in this forum. If you have any other tips, please feel free to share them. Ride safe and thanks for watching.

Youtube: https://www.youtube.com/watch?v=Nkeqay-q4u0

[video=youtube;Nkeqay-q4u0]https://www.youtube.com/watch?v=Nkeqay-q4u0[/video]

Tools:

1. a rear bike stand
2. an oil pan
3. a funnel
4. gloves
5. 5 mm allen key
6. 12 and 8 mm sockets
7. socket wrench
8. new engine oil
9. oil filter
10. compression washer
11. and oil cap gasket


Torque settings:
Oil Drain Bolt: 18 lb ft
Oil Filter Cover Bolts: 9 lb ft
 
Very nice. It's the exact same parts and procedure on a CRF250L, minus the lower fairing bit. The only thing I do different is pop the filter into the engine and use some grease to keep the spring against the filter before putting the cap back on. Also, the local Honda dealer told me the filter cover gasket doesn't need to be replaced every time. I've used mine 4 times now and no leaks.
 
Those four filter bolts still give me nightmares....don't do them tight enough and it leaks and you have to take everything off and clean the gasket. Tighten them too much (even when only holding the ratchet by the head) and they snap in half.

Don't get me wrong, I loved that bike...but I'll be happy if I never have to deal with a filter design like that again (love the spin-on used for my CBR650F...it's just like a car).
 
always informative, great videos, hope you keep it up man. i dont even own the bike and i watched the entire thing.
 
You must log in or register to reply here.

Back
Top Bottom