I've done, or at least helped with, OBR44's, Trini2Dbone's, Da-Blade's, and my own, and none of them slide at all when cold or hot!
What did you use to put the grips back on?
In all cases, we used 1 or 2 wraps of electrical tape under the heating element, nothing over the heating element, cleaned in the inside of the grip thouroughly, used a heat gun to warm up the grip, then a little bit of windex was used to help lubricate the intstall, and within a few minutes, the grip was stuck in there good, no slip at all...
Someone I know... & I won't mention any names,
used Pam cooking spray to put the grips back on, but his still slide around.
Interestingly enough,
's grips get the hottest... as if the Pam is acting as a thermal transfer enhancer (like heat sink compound). But I'd much rather have my grips tight and secure. (
's only get a few degree's hotter, but enough to notice).
Bookmarks