Hey guys...


I'm just about to install a set of Factory Pro Needles/Jets & Velocity Stacks... I'm reading through the instructions e.t.c.


Their recommended Float Height is 9.5mm.


I went through a few articles to get a better understanding of the theory, as another gentleman had mentioned his floats were set at 7.0mm. I was just wondering if there were any advantages to wards a higher or lower float height.


http://www.r1-forum.com/forums/showt...ht#post5182637


" The height is in mm. Flip your carb bank upside down and measure the height of each float from the gasket base. They should all be the same. Higher = leaner and lower = richer. "


Q: Is Higher = Leaner = Better Atomization? Lower = Richer = Poor Atomization
- like sucking out of a straw?


http://www.allthingsmoto.com/forums/...t-level-13609/


Explains Floats, but does not get into the theory of high vs. low.


Thanks!


Cheers!