So I got some goodies in the mail!
Radiantz LED Tail light board, rear clear red LED turn signals and front clear amber LED turn signals
Stock look before the change
Got the red light cover off
Radiantz LED board in place, added a bit more double sided tape, as the provided tape wasn't enough to my liking!
Testing before I close up the light
Light closed up
Closed up and Lit up
Then I went to install the LED turn signals, and the left side installed in a few seconds. When I got to the right side, I found out that the previous owner had replaced the turn signal, with what I am assuming is an older turn signal, as the bulb base is not the same as the other side. Luckily the PO did provide me with the turn signal that he replaced in case I needed an extra lens. I tried the LED bulb holder in that, and it fit as it should. So now I have to do some wiring to swap over that bulb holder into the turn signal that was replaced.
So since I couldn't do the turn signals, I decided to get the hair dryer out and remove that sticker from the fender
This thing did NOT want to peel off. Anytime I would get a good portion peeled enough to pull, it would just crack off. After a good 20 minutes of scrapping it off with my fingernails, I got it all off. Had some Goo-Gone handy to get rid of the residue, but wasn't able to get it fully off. Anyone have any better luck with it?
Thanks for looking!
Bookmarks