An update from my blog
So like I mentioned in my last post the first order of business was to install the alternator shaft which required an interference bearing to be pressed into the clutch side of the upper crank case. This turned out to be a huge pain. Heating the case and cooling the bearing didn't work. I even tried to make a half-assed bearing press which not only failed to press the bearing into place but did more harm than good.
This reeks of fail
Pictured above is a simple bearing press like any other home made device. You have a threaded rod, the bearing is fitted against a socket as shown and on the other side we have a washer to serve as a solid surface.
Oh damn, the stench of fail is overwhelming the senses
But what could go wrong with such a simple contraption? Well when the designer is a ****ing moron (yours truly) apparently a lot can go wrong. Long story short, I torque the end with the socket, the bearing starts to slide in a bit and the next minute I realize the washer pictured above had got bent and pulled through the hole it was sitting in. FUUUUUUUUUuuuuuuukkkk!!!!! At least that was my initial reaction. Upon closer inspection about half a mm of aluminum got taken out of the lip and no substantial damage was done.
See? No harm done here, moving along then....
How did the bearing finally get put in place? Well I brought it to a local shop and by gently tapping the bearing with a socket, the dude got the bearing to slide right in.... I was overcome with shame, awe and relief. I imagine this is what people feel when the suffer from premature ejaculation; something real men like me don't have to worry about har har har
This bearing is responsible for ruining my life
Yayy!!! All put together now
I turn my attention to the crank and bearings while the transmission is still out; makes mating the case halves much easier.
So much wasted plastic
Alright, LETS DO THIS!!!
Crankshaft, check...
Knockoff plastigauge, check ...
Engine bolts, check
Why, hello there Mr. Plastigauge ...
*crunch*
~0.040mm ... well, a tad on the loose side but well below the maximum
Anyways I move on to the transmission starting with *drum roll*
...the shift drum...
...and shift forks
Next I take a look at the main shaft and ...
... WTF HAPPENED HERE!??! Lucky for me I bought half a spare motor
Thats me peeing on the main shaft...
All the main shaft components in their glory
... continue ...
Bookmarks