5. Now comes the fun part!!! LETS TEST IT! Plug the stock wiring harness adapter (that thing you removed the blue plug from and put it back on) back into the blue plug below the headlight assembly. This part is important because I forgot to take a pic of it. The power assembly that was with the HID bulb that you cut free from the rubber grommet, each "blade" plugs into the factory headlight harness adapter. Just push the blade into the headlight connector, it doesn't matter right now which one goes where. Plug the ballast high voltage wires into the bulb high voltage wires. THAT'S IT! YOUR HID KIT IS DONE! Well except for the mounting
LICK FOR HIGH RES!
Time for the test. Follow these instructions EXACTLY!
-Make sure your high beam switch is OFF
-Start the motorcycle (actually start it, don't just turn the key on).
-Let it run for 60 seconds.
-Click the highbeam switch on.
BOOM! You should have wonderful glorious HID brightness
IF NOT, TURN THE HIGH BEAM SWITCH OFF THEN TURN THE BIKE OFF, switch around the two spade connectors that you slid into the headlight connector a second ago (unplug them, and plug them in to the opposite slot it was in). Sorry that I forgot to take pics of this Repeat the test from the beginning, make sure to let the motorcycle run for 60 seconds or LONGER on the second test before clicking the highbeam switch on, etc.
OMG IT WORKS!
LICK FOR HIGH RES!
6. Now you have to mount it. I won't hold your hand here, the hard part is done. I prefer zip ties over two sided tape or velcro any day! The DDM digital 55w ballast fit perfectly in the space between the bottom of the headlight assembly and the radiator air duct bodywork (same on both sides). I then zip tied the igniter (black box with the high voltage wires going to bulb) to the plastic tab that already had something zip tied to it from the factory (perfect spot). I zip tied the ballast to the wiring harness by the white tie that's screwed to the bodywork under the headlight assembly.
LICK FOR HIGH RES!
(toggle switch is for the heated grips )
LICK FOR HIGH RES!
LICK FOR HIGH RES!
Wow, so clean
Now, for the other side (low beam), wash, rinse, repeat.
LICK FOR HIGH RES!
LICK FOR HIGH RES!
LICK FOR HIGH RES!
OMG DUAL HID'S!
LICK FOR HIGH RES!
Sweeeeeeeeet.
-Jamie M.
Bookmarks