I chose to build it myself...
1. Get a rough estimate of the length of wire you will need to run from where you will mount the selector switch to where your Bazzaz zfi unit is. Cut 2 pieces of wire of the same length.
2. Solder one wire to the common connection of the toggle switch (usually the centre tab) and the other wire to one of the other tabs. If you have a multi meter you can check the continuity and verify you have an open and closed connection.
3. Use shrink tube to cover switch and the whole length of wire. If there is no shrink tube available, you can also wrap the switch and wire with electrical tape.
4. Snake the wires through the bike to your Bazzaz zfi.
Bookmarks