|
This is the piece I'm talking about, just to give a visual...I give up...and so did my dremel LOL:
Last edited by dafy; 11-24-2009 at 07:29 PM.
aluminium is too soft. the sand will literally eat through the part very quickly if not careful. same with steel, but it takes much longer since its that much harder.
i made this mistake before with Fishburn Proctor. never again.
walnut shell,etc,etc is soft so it will only take the paint off. You can also try chemical stripping.
Last edited by DY; 11-24-2009 at 08:35 PM.
FS:[99-02 SV650 Parts, R6 Rim] [SV650 Brake Pads] [50MM Headlight Bracket] [SuperCorsa Scrubs 120/180]
I want these parts gone! make me an offer.
please email me directly, I don't check the forums anymore. Thanks!
If you can get it up to Concord, I can blast it for you. It looks very small.
We use glass bead and I am glassbeading all my alum. stuff for my FZR. If you can get it to me, I'll do it for free.
PM me if you want a phone number and directions.
Bookmarks