|
building a dash plate for my cafe..
i've checked the "locals" H.D./C.T./P.A./lowes
I need a plate of aluminum.
6 inchs wide
7 inchs tall
3/8ths thick..
any ideas? i live in whitby.
Knowledge Without Mileage is Useless
*worry about your own spelling not mine.
I wave at kids as I pass them in a hope that there's a gray-pants-wearing, beige-volvo-driving accountant somewhere in the future that dies everytime I do.
Seach for your local metal supermarket, most of them have a shear and will cut to size or if your lucky you will find something close enough in the cut offs section
Look for busted road signs
I made some brackets from a spare DANGER High Voltage Overhead Wires sign.
If you want precisely sized stuff of whatever exact alloy type you need, check these guys out:
http://www.metalsupermarkets.com/MSC...on=ON&City=GTA
They have a location in Scarborough.
Edit ah too slow, Johnny mentioned them first
i got some kicking around, but i dont think its 3/8's
but i'm in Etobicoke a bit out of your way.
99 Honda VTR1000F Firestorm
I have lots of 1/4" off cuts I could shear to size for you. I know I have a 3/8" sheet out there, not sure about off cuts.
located in scraborough around the corner from the old cycle world east
Metal Supermarkets should have it.
I might have some kicking around the shop. Problem is I am working in Smiths Falls right now.
I'll have a look when I get back in a couple days.
05 DRZ400SM
93 ZX-7
02 RM125
Bookmarks