Re: FZR"400" project build
http://www.microsquirt.info/uswiring.htm
Also the wiring diagram here shows a 2amp fuse. I am using a 3amp.... is that a big deal? I couldn't find any 2a fuses readily available.
And one more question, All 4 injectors run off the same power which in the diagram they showed each bank running off a different set and then each fused at 5a.
So since they all run one power line I put in a 5a fuse. Is this the right thing to do? Or was I suppsoed to run a 10a?
Re: FZR"400" project build
3 amp fuse is fine. You should move to a 10amp for 4 injectors.
Re: FZR"400" project build
Quote:
Originally Posted by
Freestyle72
http://www.msextra.com/doc/general/ms2external.html
If you look at the diagram posted there:
What I did was take my fuel pump relays 85 and 87 wire and coupled those two to the line going to the 3a fuse. So now I have 3 wires meeting in one spot. Then I am going to plug that into the black/blue wire on the FZR which is the CDI feeds from the main relay or would be similar to the wire 30 on the msextra diagram.
Did I do that correctly? I wish I wasn't so dumb at this stuff haha. But I don't want to burn up my $400 ECU.
What about this. Did I understand the wiring correctly?
Re: FZR"400" project build
Quote:
Originally Posted by
Freestyle72
What about this. Did I understand the wiring correctly?
I can't figure out what you are talking about here. Maybe MS Paint it?
I'd have to take a look at the MicroSquirt diagram, but it should have some pretty good protection on it. The regular megasquirt does. I wouldn't worry about screwing it up through the main power. You're more likely to screw up one of the sensor inputs than the main power feed.
Re: FZR"400" project build
Re: FZR"400" project build
What ever happened to this thread? and racing it against another FZR 400?
Re: FZR"400" project build
Well the bike is in pieces again for fuel injection... and theres my home wiring project that has my attention right now... soon as I have the welder up and running I will try to weld some brackets and stuff that I need to finish putting this bike back together. As far as racing it against another FZR maybe next season.
Re: FZR"400" project build
Quote:
Originally Posted by
Freestyle72
Well the bike is in pieces again for fuel injection... and theres my home wiring project that has my attention right now... soon as I have the welder up and running I will try to weld some brackets and stuff that I need to finish putting this bike back together. As far as racing it against another FZR maybe next season.
I want to come watch, please keep us updated ....