Printable View
Anyone know if this is a "legal" modification in place of the stock tail/signal lights as far as MTO is concerned? In other words, would I get nailed when I went to safety the bike if I had this installed?
1994-2003 Ducati 748 916 996 2002-2004 998 LED Tail Light Integrated Smoke Motodynamic.com
Looks amazing and would love to swap out my old euro-style plate holder/rear signals for this.
<!-- / message --><!-- sig -->__________________
Technically no it's not legal, but I doubt you will have any issues about it.
I think legally your turn signals are supposed to be 12" or 14" apart (Not 100% on the numbers), Chances of getting a ticket are very slim though.
I remember reading somewhereQuote:
Originally Posted by jeffjones
minimum of 8", I'll have to look it up now :(.
At or near the rear - 1 red or amber on each side of the vertical centerline, at the same height and having a minimum horizontal separation distance (centerline to centerline of lamps) of 230 mm (9 inches). Minimum edge to edge separation distance between lamp and tail or stop lamp is 100 mm (4 inches), when a single stop and tail lamp is installed on the vertical centerline and the turn signal lamps are red.Quote:
Originally Posted by boooya
http://www.tc.gc.ca/eng/roadsafety/s....htm#Table III
From what I can see a min of 150mm from the center stop lamp on either side.
That's actually not a bad little thing....looks pretty bright plus has a reflector.
Dont think the cops would hassel you. Kawi's have LED brake lights....the blinkers might not be the most visible or things....
I had something similar on my RR and never had an issue once ..
The only issue might be if your going to get your bike certified and then again you can always go to crappytire and get it done there with no problems... They didnt even know how to put my bike in gear let alone start it yet they passed me because it had lights that worked and tire tread... Even though they were cracked on the sidewall lol
Quote:
Originally Posted by jeffjones
The way I read that is that the minimum seperation is for red turn signals. It doesn't specify seperation for amber when it's a single unit.
At or near the rear - 1 red or amber on each side of the vertical centerline, at the same height and having a minimum horizontal separation distance (centerline to centerline of lamps) of 230 mm (9 inches). Minimum edge to edge separation distance between lamp and tail or stop lamp is 100 mm (4 inches), when a single stop and tail lamp is installed on the vertical centerline and the turn signal lamps are red.Quote:
Originally Posted by sircastic
Two separate sentences. The horizontal separation distance applies regardless of signal colour. The separation from the brake lamp applies if the turn signals are red.
For the device listed in the original post, it does not conform to the horizontal separation distance requirement.